Experimental study on the condensation of supersonic steam jet submerged in quiescent subcooled water: Steam plume shape and heat transfer

The condensation of supersonic steam jet submerged in the quiescent subcooled water was investigated experimentally. The results indicated that the shape of steam plume was controlled by the steam exit pressure and water temperature. Six different shapes of steam plume were observed under the present test conditions. Their distribution as a function of the steam exit pressures and water temperatures was given. As the steam mass velocity and water temperature increase, the measured maximum expansion ratio and dimensionless penetration length of steam plume were in the ranges of 1.08–1.95 and 3.05–13.15, respectively. The average heat transfer coefficient of supersonic steam jet condensation was found to be in the range of 0.63–3.44 MW/m²K. An analytical model of steam plume was found and the correlations to predict the maximum expansion ratio, dimensionless penetration length and average heat transfer coefficient were also investigated.     

Coupled modeling of damage growth and permeability variation in brittle rocks

This paper presents a coupled model for anisotropic damage and permeability evolution by using a micro–macro approach. The damage state is represented by a second order tensor. The evolution of damage is determined from a crack propagation criterion. The free enthalpy function of cracked material is obtained by using micromechanical considerations. It is assumed that cracks exhibit normal aperture which is coupled with the crack growth due to asperities of crack faces. By using Darcy’s law for macroscopic fluid flow and assuming laminar flow in microcracks, the overall permeability of the RVE is obtained by a volume averaging procedure taking into account crack aperture in each orientation.     

SOIL AGGREGATE AND ITS RESPONSE TO LAND MANAGEMENT PRACTICES

This paper provides a broad review of the existing study on soil aggregate and its responses to land management practices. Soil aggregate is used for structural unit, which is a group of primary soil particles that cohere to each other more strongly than other surrounding particles. The mechanism of soil particle aggregation may be expressed by a hierarchical model, which is based upon the hypothesis that macroaggregates （〉250μm） are collections of smaller microaggregates （〈250μm） held together with organic binding agents. Primary particles form microaggregates and then macroaggregates. Carbon （C）-rich young plant residues form and stabilize macroaggregates, whereas old organic C is occluded in the microaggregates. The interaction of aggregate dynamics with soil organic carbon （SOC） is complex and embraces a range of spatial and temporal processes within macroaggregates and microaggregates. The nature and properties of aggregates are determined by the quantity and quality of coarse residues and humic compounds and by the degree of their interaction with soil particles. The mechanisms resulting in the binding of primary soil particles into stable aggregates vary with soil parent material, climate, vegetation, and land management practices. Land management practices, including tillage methods, residue management, amendments, and soil fertility management, enhance soil aggregation. However, there is still much uncertainty in the dynamics of organic matter in macroaggregation and microaggregation, and research is still needed to understand further the mechanisms of aggregate formation and its responses to human activities.     

耐磨环氧胶粘涂层冲蚀磨损特性的研究

本文对气固冲蚀和浆体冲蚀条件下耐磨环氧胶粘涂层的磨损特性进行了研究。结果表明,这种涂层的冲蚀磨损是由粘结剂的磨损和抗磨填料的磨损所组成;填料粒度和磨料粒度都对涂层的气固冲蚀磨损有影响,但在给定的试验条件下,填料粒度对涂层的浆体冲蚀磨损影响甚微。文章指出,耐磨环氧胶粘涂层在气固冲蚀和浆体冲蚀下的磨损机理相似,但磨损规律却有所不同;耐磨环氧胶粘涂层尤其适用于浆体冲蚀的场合,可以明显地提高机械过流部件的使用寿命。     

紊动流场中悬浮颗粒分布的随机理论

通过分析固体颗粒在紊动流场中的随机运动,建立了二维流场中垂直于时均流动的方向上颗粒随机位移的概率密度分布函数所满足的方程。由该方程解出的分布函数在一定条件下即相当于颗粒浓度分布函数。运用这一方法研究了[1]、[2]中报道的壁面附近颗粒浓度降低的现象。     

作动器参数对结构性能的影响和调整受力状态的实施策略模拟

基于规划法研究了作动器各参数对自适应超静定桁架性能的影响。该规划法能够使结构工作状态更合理化。这一方法能够改善自适应结构的工作状态因而提高承载能力。以此为基础，研究了具有作动器的组合杆的有关参数诸如变形上限、刚度和承载力上限对于控制效果的影响。从而为作动器的合理选择提供了理论根据。对于调整作动器变形以控制结构强度的实施策略进行了模拟和分析。该策略包括3部分：1．模拟和分析了“加载、调控、卸载”重复循环直至调控的完成；2．不同作动器按比例同时放大变形直到调控实现；3．多次加载、调控同一次加载、调控结构的等价性。研究表明本文提出的使结构工作状态合理化的调控过程是安全、可靠和灵活的。     

Chiral Phosphoric Acid Catalyzed Atroposelective C−H Amination of Arenes

N‐arylcarbazole structures are important because of their prevalence in natural products and functional OLED materials. C?H amination of arenes has been widely recognized as the most efficient approach to access these structures. Conventional strategies involving transition‐metal catalysts suffer from confined substrate generality and the requirement of exogenous oxidants. Organocatalytic enantioselective C–N chiral axis construction remains elusive. Presented here is the first organocatalytic strategy for the synthesis of novel axially chiral N‐arylcarbazole frameworks by the assembly of azonaphthalenes and carbazoles. This reaction accommodates broad substrate scope and gives atropisomeric N‐arylcarbazoles in good yields with excellent enantiocontrol. This approach not only offers an alternative to metal‐catalyzed C–N cross‐coupling, but also brings about opportunities for the exploitation of structurally diverse N‐aryl atropisomers and OLED materials.     

Facile Synthesis of Enantiopure Sugar Alcohols: Asymmetric Hydrogenation and Dynamic Kinetic Resolution Combined

An unprecedented Ir/f‐amphox‐catalyzed asymmetric hydrogenation of racemic 2,3‐syn‐dihydroxy‐1,4‐diones is presented involving dynamic kinetic resolution, which produces (1R,2R,3R,4R)‐tetraols. This protocol constitutes an efficient and straightforward approach to accessing sugar alcohols bearing four contiguous stereocenters. The strategy exhibits various advantages over existing methods, including excellent yields (up to 98 %), exceptional stereoselectivities (up to 99:1 dr, 99.9 % ee), operational simplicity and substrate generality. Moreover, the nature of the reaction was revealed as a stepwise transformation by in situ Fourier‐transform infrared spectroscopy and isolation of intermediates.     

Enhancement of Nb-doping on the properties of LiFePO4/C prepared via a high-temperature ball milling–based method

Journal of Solid State Electrochemistry - Li1-xNbxFePO4/C has been prepared by wet mechanical stirring–assisted high-temperature ball milling route. Wet mechanical stirring was considered to...